Quick Start Guide: Matte Box Adapter for Grip Rig 2

Unboxing & Overview

In the Box

• Matte Box/82mm Filter Adapter (95/115mm)
• 2x Embedded 1/4-20 Screws

What You Need

• Grip Rig 2 (the adapter mounts to the top of the handles)
• DJI Osmo Pocket 3
• 95 mm or 115 mm clamp matte box or 82 mm filter/accessory

Important to Know (Read First)

• The adapter creates a short "tunnel." You may see the edges of the opening in your shot if the camera isn't centered or during extreme moves—this is normal.
• Best for stationary shots. Moving shots can work if set up correctly (see tips below).
• No whip pans or very fast moves with the adapter attached.
• Battery handle is not compatible with the adapter attached.

How to Install

1. Mount the Adapter

Place it on top of the Grip Rig 2 handles. Insert the two 1/4-20 screws and tighten with a 3 mm tool. Snug—don't over-tighten.

2. Seat the Camera

Gently slide the Pocket 3 gimbal into the ultrasuede hood until fully seated. Attach your camera to quick release.

3. Add Your Front Accessory

Attach your 95 mm/115 mm matte box or any 82 mm filter/accessory.

4. Power On & Check Clearance

Turn on the Pocket 3 and make sure the gimbal moves freely without touching the adapter or accessory.

Tips for Best Results (Especially When Moving)

• Set the Pocket 3 to Follow Mode → Follow Speed: FAST. (Normal is okay; Slow usually isn't.)
• Keep the adapter level with the ground while you frame and move around.
• If the camera drifts off-center, double-tap the Thumb Controller to re-center. Hold the rig level while it recenters.

Mounting Options

There's a 1/4-20 port on the bottom of the adapter for a tripod or quick-release plate.

Quick Troubleshooting

• Edges in frame: Re-center (double-tap), keep the rig level, or slow down your move.
• Gimbal bumps on start-up: Remove/adjust the front accessory and re-seat the camera, then power cycle.
• Adapter feels loose: Re-snug both 1/4-20 screws (3 mm tool).

Need Help?

Any issues or questions please start a chat on the store!